CSS Exam Info
Home » CSCS Mock Test » Specialists Test » Supervisory » CSCS Supervisor Practice Test 5
HS&E TEST
CSCS Supervisor Practice Test 5
1 / 50
Under the requirements of the Work at Height Regulations, what must the minimum width of a working platform be?
2 / 50
What is the best way for a supervisor or manager to make sure that the operatives doing a job have fully understood a method statement?
3 / 50
Which material or substance is most likely to give off hazardous vapour?
4 / 50
What is the main risk to this worker, wearing only these items of personal protective equipment (PPE)?
5 / 50
Why is it important to report near miss incidents on site?
6 / 50
What should be the capacity of a spillage bund around a fuel storage tank, in addition to the volume of the tank?
7 / 50
If a scaffold is not complete, which of the following actions should be taken by the supervisor?
8 / 50
Why is methane gas dangerous in confined spaces? Give two answers
9 / 50
At what minimum noise level must you provide hearing protection to workers if they ask for it?
10 / 50
What is the organisation 'The Samaritans' ?
11 / 50
What does this sign mean?
12 / 50
What is regarded as the last resort in the hierarchy of control for operatives' safety when working at height?
13 / 50
If there is a fatal accident or a reportable dangerous occurrence on site, when must the Health and Safety Executive (HSE) be informed?
14 / 50
What is the maximum vertical height that a fixed ladder can be climbed, before an intermediate landing place is required?
15 / 50
What should you do if you are concerned about a colleague's mental health?
16 / 50
What are the minimum facilities that must be provided on site for washing your hands?
17 / 50
What is the main hazard associated with the movement of plant and machinery around site?
18 / 50
Which of the following is a fall-arrest system?
19 / 50
Why is it important that hazards are identified?
20 / 50
Which two of the following will help you to find out about the site emergency procedures and emergency telephone numbers?
21 / 50
How should access be controlled if people are working in a riser shaft?
22 / 50
What does the term lower exposure action value (80 decibels (dBA)) mean, when referring to noise?
23 / 50
Why is it important to wash your hands after handling lead, or lead based paint, before eating or smoking?
24 / 50
If you need to stack materials on a working platform, what is the best way to stop them falling over the toe-board?
25 / 50
Which of the following is not true when using podium steps?
26 / 50
A mobile crane is lifting a load but the load is about to hit something. What should you do?
27 / 50
What do the initials HAVS stand for?
28 / 50
A design feature of some airbags used for fall arrest is a controlled leak rate. If you are using these, what must you ensure about the inflation pump?
29 / 50
Why should a residual current device (RCD) be used with 230 volt tools?
30 / 50
Under the Construction (Design and Management) Regulations 2015, what must be provided before construction work starts, and then maintained until the end of the project?
31 / 50
Which of the following do you not need to do to ensure that someone's mask works?
32 / 50
When do the Work at Height Regulations require a working platform to be inspected by a competent person?
33 / 50
Which sign is categorised as a warning sign?
34 / 50
Which of the following best describes the purpose of personal fall prevention equipment?
35 / 50
What is the maximum unprotected gap allowed between any guard-rail, toe board, barrier or other similar means of protection on a scaffold?
36 / 50
Exposure to which of the following is most likely to result in dermatitis?
37 / 50
What should you do if you have been told how to lift a heavy load but you think there is a better way to do it?
38 / 50
Which of the following should be the first consideration if you need to use a hazardous substance?
39 / 50
What should be done with waste concrete and washout water?
40 / 50
Why must a residual current device (RCD) be used in conjunction with 230-volt electrical equipment?
41 / 50
Which of the following tasks would you expect the appointed person for first aid to carry out?
42 / 50
How is it possible to tell that a product is hazardous?
43 / 50
What piece of personal protective equipment (PPE) should be worn on sites where there is a risk of falling objects?
44 / 50
From a safety point of view, which of the following should be considered first when deciding on the number and location of access and egress points on a site?
45 / 50
Which two of the following factors must be considered when providing first-aid facilities on site?
46 / 50
When does an employer have to prepare a written health and safety policy?
47 / 50
What are two possible consequences for employers of not taking measures to prevent accidents and ill health at work?
48 / 50
What is the main danger of leaving someone who has fallen suspended in a harness for too long?
49 / 50
What will safety footwear with a protective mid-sole protect you from?
50 / 50
Ideally, where should a safety net be rigged?
Your score is
The average score is 84%
Restart quiz Exit
How was the test? Please Submit your Rating and give a feedback!
Your email address will not be published. Required fields are marked *
Δ
